1999 Kia Sportage Drivetrain – 4WD Control Vacuum Line

Posted on 22 December 2013 by admin

Download 1999 Kia Sportage Drivetrain – 4WD Control Line – CONDITION 4 wheel drive mode inoperative (diagnosed either during or after replacing knuckles and hub seals) due to insufficient vacuum being applied to the hubs. CAUSE In some cases moisture has entered the vacuum system, and vacuum lines have become corroded, plugged, or have developed a leak. CORRECTIVE ACTION Verify that with 4 wheel drive mode selected, vacuum is present at the T-fitting downstream from the solenoid (see photo). If not, diagnose and repair as required, otherwise use the following procedure to replace the vacuum lines: Note: Procedure applies to right side line; left side needs no further info. Disconnect and remove battery and battery tray. Leaving ground cables attached, remove clamp bracket from battery tray bottom and move out of the way. Remove plastic air resonator and disconnect throttle cable (plus A/T control cable if equipped). Disconnect MAF and IAC connectors, and 6 mm bolt holding DLC and MAF brackets to air cleaner housing. Disconnect air intake tube from throttle body, and MAF sensor from air

Comments are closed.

Auto Repair Manual
Free Auto Repair Manuals PDF Download

Auto Service Manual
Free Auto Service Manuals PDF Download

Service & Repair Manual Free Download
Automotive, Computer, Printer, HandPhone, Tablet, Tips and Tricks...etc. Visit US ...

Car Repair Manual
Free Car Repair Manuals PDF Download

Car Service Manual
Free Car Service Manuals PDF Download

Auto Repair Magazines
Free PDF Download & Review

Auto Service Magazines
Free PDF Download & Review

Ndarzone | Article, New and Science

suggest listing
PR5 Free Web Directory - Submit URL >>

Ads by Iskandar
You might also likeclose