Download 2006 Saturn VUE Brake Pads Repair Manual – 1. Inspect the fluid level in the brake master cylinder auxiliary reservoir. 2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding. 3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding. 4. Raise and support the vehicle. Refer to Vehicle Lifting. 5. Remove the tire and wheel assembly. 6. Install and firmly hand tighten 2 wheel nuts to opposite wheel studs in order to retain the rotor to the hub. 7. Install a large C-clamp over the body of the brake caliper with the C-clamp ends against the rear of the caliper body and against the outboard brake pad. 8. Tighten the C-clamp evenly until the caliper piston is compressed into the caliper bore enough to allow the caliper to slide past the brake rotor. 9. Remove the C-clamp from the caliper. 10. Remove the brake caliper lower guide pin bolt. 11. Notice: Support the brake caliper with heavy mechanic’s wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected.